5. INSTALLATION INSTRUCTIONS
5.1 Exhausting hot air
In the Cool Mode the appliance must be
placed close to a window or opening so
that the warm exhaust air can be ducted
outside� First position unit on a flat floor
and make sure there's a minimum of
30mm clearance around the unit, and is
within the vicinity of a single circuit outlet
power source�
1. Extend either side of the hose(Fig�1) and
screw the hose to connector A (Fig�2)�
2. Extend the other side of the hose and
screw it to connector B (Fig� 3)�
3. Install the connector B into the unit
(Fig�4)�
2
Lock
3. Affix the connector A into the window
slider kit and seal� (Fig�5&6)
Slide onto
1
Fig.1
The hose can be extended from
its original length of 38cm up to
150cm, but it is the best to keep
the length to minimum required�
Also make sure that the hose does
not have any sharp bends or sags�
(Fig� 7)
5.2 Installation in a double-hung
sash window
1. Cut the foam seals A(adhesive type) to
the proper lengths and attach them to
the window and stool�(Fig�8)
Fig. 4
ENGLISH
11
Fig.7