Replacing The Lamps - Beko HCA63640B Benutzerhandbuch

5
Cleaning and maintenance
5.3 Cleaning
Particularly do not neglect to clean your hood im-
mediately after you have made frying.
Use a soft cloth soaked with liquid detergent to
clean the outer surface of your hood.
Never use abrasive or scratching materials for
cleaning.
You may use the cleaning agents commercially
available for persistent grease etc. by following
the warnings on the product. In order not the
scratch the brushed steel body, wipe in the same
direction with the bush trace.
Do not use cleaning agents containing hydro-
chloric acid, bleach or abrasive powders in order
to maintain the surface quality of your product.
Use a cloth dampened in soapy water or special
stainless steel cleaning spray for stainless steel
steel surfaces. Remove the protective foil on the
appliance.
Caution!
A
You may cause a fire if you do not
follow the instructions on the clean-
ing and replacement of the filters of
your hood.
If you need to transport the appliance:
• Keep the original packaging of the appliance.
Transport the appliance with its original pack-
age, and follow the transport markings on the
original package.
If you do not have the original package:
• Do not place any objects on the hood.
• Protect the outer surface from impacts.
• Pack the appliance so that it would not be dam-
aged during transport.
Hood / User Manual

5.4 Replacing the lamps

Disconnect the hood from the mains supply.
This appliance is equipped with 3 W halogen
lamps.
To replace the halogen lamps, press the lamp
downwards from the rear section of the lamp
holder to release the lamp. Then turn it counter-
clockwise by 1/4 tour and remove it.
Perform the above steps in reverse order to fit the
new lamps.
Note:
You may procure lamps from Authorised Service
Agents.
33 / EN