HP ProLiant Gen8 Handbuch Seite 6

Swapped Cables or Configuration Error Detected. A Drive Rearrangement... . 18
Swapped Cables or Configuration Error Detected. An Unsupported Drive
Arrangement Was Attempted... ......................................................................... 18
Swapped cables or configuration error detected. The cables appear to be
interchanged... .................................................................................................. 18
Swapped cables or configuration error detected. The configuration
information on the attached drives... ................................................................. 19
Swapped Cables or Configuration Error Detected. The Maximum Logical
Volume Count X... ............................................................................................. 19
System Board is Unable to Identify which Slots the Controllers are in ............. 19
The Redundant Controllers Installed are not the Same Model... ...................... 20
This Controller Can See the Drives but the Other Controller Can't ................... 20
This Controller Can't See the Drives but the Other Controller Can ................... 20
Unable to Communicate with Drive on SCSI Port X, Drive ID Y ....................... 20
Unable to Retrieve Identify Controller Data. Controller May be Disabled or
Failed ................................................................................................................ 21
Unknown Disable Code ..................................................................................... 21
Unrecoverable Read Error ................................................................................ 21
Unsupported Processor Configuration (Processor Required in Slot #1) ........... 21
Warning Bit Detected ........................................................................................ 21
WARNING - Drive Write Cache is Enabled on X .............................................. 21
WARNING - Mixed Feature Processors Were Detected ................................... 22
WARNING - Resetting Corrupted CMOS .......................................................... 22
WARNING - Resetting Corrupted NVRAM ....................................................... 22
WARNING - Resetting Corrupted System Environment ................................... 22
WARNING - Restoring Default Configurations as Requested .......................... 22
WARNING: Storage Enclosure on SCSI Bus X Indicated it is Operating in
Single Ended Mode... ........................................................................................ 22
Write Memory Error ........................................................................................... 22
Wrong Accelerator ............................................................................................ 23
Fehlermeldungen für ADU-Version 8.0 bis 8.28 ................................................................ 23
Array Accelerator: The batteries were hot-removed ......................................... 23
Array Accelerator: The cache is disabled because the batteries are low on
the redundant controller .................................................................................... 23
Array Accelerator: The cache for this controller is temporarily disabled
since a snapshot is in progress.... ..................................................................... 23
Array Accelerator: The cache is disabled because the batteries are low .......... 23
Array Accelerator: This controller has been set up to be a part of a
redundant pair of controllers... .......................................................................... 23
Array Accelerator: The cache is disabled because the restore operation
from flash memory failed ................................................................................... 23
vi DEWW