Inhaltsverzeichnis
Werbung
6. Technische Daten: pocket tools dual para eq
Technical data
Input
input
Unbalanced line input
¼" jack (6.35 mm)
Gain adjustment range: –10...+10 dB,
0 dB at center notch of gain control.
Min. input voltage: 300 mV (–10 dBV)
Max. input voltage: 9 V (+19 dBV)
Input impedance: 10 k
Signal-to-noise ratio (A-weighted)
0 dB gain: 108 dB
Min. gain: 108 dB
Max. gain: 103 dB
Frequency response: 20 Hz...20 kHz / 0.5 dB
THD + N (1 kHz): < 0.1%
Phantom power: Ring contact of line out is
connected to ring contact of input. Any
external phantom power applied at the ring
of line out will be available at the input.
Clip indicator
Red LED
Headroom: 12 dB
Output
line out
Unbalanced line output
¼" jack (6.35 mm)
Nominal output voltage: 1 V (0 dBV)
Max. output voltage: 9 V (+19 dBV)
Output impedance: 47
Min. load impedance: 2 k
Parametric equalizer
Number
Two adjustable band boost / cut (bell curve)
and type
filters
of filters
Frequency
90 Hz...1.6 kHz / 680 Hz...11 kHz
range
Both filters are switchable to either frequency
range.
15 dB at center frequency of filter
Gain range
Bandwidth
0.4 – 2.2 octaves
range
("half-dB" method, measured between +7.5
dB points with level set to +15 dB)
Power
Supply
24 V=, 0.2 A
voltage
Use only supplied mains adapter.
Mains
Mains voltage: 100-240 V~
adapter
Power consumption when used with Dual
Para Eq: max. 10 W
General
Metal
Aluminium
housing
Finish
Anodized black
Dimensions 65 mm (2.56") high
105 mm (4.13") wide
135 mm (5.31") deep
Weight
430 g (0.95 lbs)
Definitions and conditions
Input and output voltages are RMS values for a sine signal
and 1 kHz unless stated otherwise.
Tone controls in neutral position (equalizer level in center
position) unless stated otherwise.
Min. input voltage: Input voltage for nominal output
voltage at line out with gain fully clockwise.
Max. input voltage: Permissible input voltage that does not
cause distortion more than the rated THD + N (assuming
suitable control settings).
Signal-to-noise ratio (SNR): Ratio of nominal output voltage
to noise voltage at line out, at specified gain setting, input
shorted, 20 Hz...20 kHz.
THD + N: Total harmonic distortion + noise for nominal
output voltage at line out
Specifications and appearance subject to change without
notice.
TD20111123
7
Werbung
Inhaltsverzeichnis
