Key Automation VIPER LED Anleitungen Und Hinweise Zu Installation Und Einsatz Seite 26

EN
4.12 Setting reception mode
The control unit is set for the radio control of all Key Automation transmitters.
Press"+" to display "5"
Note: in order to exit the programming and save the parameters push P button for 5 seconds.
4.13 Photocell Function Setting
(Default setting: "0")
Press"+" to display "6" Photo-
cell is always active in closing
Through this function with the door closed and photocell interrupted, it is possible to enable/disable the opening command
Note: in order to exit the programming and save the parameters push P button for 5 seconds.
4.14 Setting of the duration of automatic closure
(Default settlng: "0")
Press"+" to display "7"
Value
Time
Note: in order to exit the programming and save the parameters push P button for 5 seconds.
4.15 Setting of alarm for 2000 operating cycles
(Default setting: "0")
Press"+" to display "8"
Silencing the acoustic alarm: power off, then power on again, or press the door control keys + or - for 5 seconds
Note: in order to exit the programming and save the parameters push P button for 5 seconds.
26
Press "P", on the display '1"
flashes, to indicate that the set
radio decoding is ROLLING
CODE (default setting); if 2 is
selected on the display the set
radio decoding is FIX CODE
Press "+", the display shows "1",
to indicate that the photocell is
active during opening
Press "P" to show "0", the func-
tion is not active (default set-
ting)
0 1 2
not active 5 sec 10 sec
Press "P". The display shows
"0" to indicate that the function
is not active (default setting)
Press "+" o "-" to select the de-
sired type of decoding
Press "P", the display shows
"0", to indicate that the photo-
cell is not active during opening
(default setting)
Press"+" to show "1" and acti-
vate the function. The duration
automatic closing is 5 seconds
3 4 5
20 sec 30 sec 60 sec
Press "+". The display shows
"1" to indicate that the function
is active
Press the key "P" to show "5",
and save the settings.
Press "P" again to save the set-
tings
Press "+",or "-" to select the du-
ration following the table below
Press "P" again to save the set-
tings
6 7 8
120 sec 180 sec 240 sec
Press "P" again to save the
settings