Philips SalonCurl Ceramic HP4658 Bedienungsanleitung Seite 8

EnglisH
8
styling with the curling iron
1 Insert the mains plug into the wall socket. (Fig. )
 Switch the appliance on by setting the on/off slide to 'I'. (Fig. )
The green power-on light goes on. It stays on as long as the on/off slide is
set to 'I'.
After approximately 3 minutes the dot on the barrel changes colour
(becomes lighter). The appliance is now ready for use.
 Take a lock of hair, open the clip by pressing the lever and place the
lock between the barrel and the clip. (Fig. )
The thinner the lock of hair, the tighter the curl will be. In this way the full
length of the strand will come in contact with the heated barrel.
 Release the lever (Fig. 5)
5 Slide the barrel to the end of the lock. (Fig. 6)
6 Wind the lock round the barrel. (Fig. 7)
Make sure the end of the lock is wound in the required direction.
7 Keep the curling iron in your hair for approximately 15 seconds.
(Fig. 8)
8 Unwind the lock of hair until the clip can be opened again by means
of the lever. (Fig. 9)
You can comb the curls with your fingers to add volume.
,
styling with the slide-on brush (HP4658 only)
You can use the slide-on brush to create waves and to add volume to
your hair.
1 Slide the brush onto the barrel of the appliance. (Fig. 10)
Be careful! If you have just used the curling iron, the barrel will still be
hot.
 Insert the mains plug into the wall socket. (Fig. )
 Switch the appliance on by setting the on/off slide to 'I' (Fig. )