jbc Advanced JT 7700 Instruktionshandbuch Seite 10

ENGLISH
2 Place the component or printed circuit.
3 When the component is correctly placed,
solder its pins.In the case of integrated circuits
of the Flat Pack type, first solder one pin of
every IC angle to fix it in place in the circuits.
4 Apply FL 9582 flux ref. 0046565 in pads and
leads.
5 Solder the remaining pins. For that, we
recommend you, use our Advanced
soldering stations, which has 2 models of
irons:
2210 handpiece ref. 2210000 for great
precision tasks, like SMD solders, etc.
2245 handpiece ref.2245000 for general
soldering tasks in professional electronics.
These soldering irons have a wide range of
cartridges with different models of tips. The
cartridge 2245-009 and 2245-010 are
specially designed for soldering SMD circuits
of the QFP and PLCC types.
Solder wire with a diameter of between 0.5 and
0.7 mm should be used.
6 Depending on the nature of the component to
be soldered, use soldering paste together
with our hot air station TE 5400, which gives
very accurate air-flow regulation, between
4 and 12 l/min.
8