Measurement Parameters (Temperature, Stability, Time Limit, Sequence) - Mettler Toledo RA-510M Bedienungsanleitung

Methods
7.3.1 Measurement parameters
– Press the Meas. Para. key (method 1 selected):
-MEAS. PARA.-
M.Temp
Stability :
Limit time :
Sequence :
Note: You can select the temperature unit "°F" with the function key (see Section 8.10).
Stability: Stability of the measured value, entry can be 0, 1 or 2.
0: Measurement repeatability of ±2
60 seconds
1: Measurement repeatability of ±5
30 seconds
2: Measurement repeatability of ±1
15 seconds
Limit time: Time limit for the measurement, input range: 0 to 9999 s.
When the defined time has elapsed, the measurement is stopped even if the
measured value is not yet stable.
If you enter 0, the measurement time depends on the selected stability only.
Sequence: If you have attached the automatic sampling unit, use this parameter to define
the sequence of sample addition and draining, rinsing and drying of the cell.
Sequence: 0
0: no instrument attached or action not desired
1: action will be performed within a defined time (see Section 9.1.3)
2: duration of the action will be defined automatically (see Section 9.1.3)
16
[Method 1]
: [ 20.00]°C
[1]
[ 600]sec
[00000]
0 0
M. Temp:
Set value of the temperature at which
the samples should be measured. Input
range: 15.00 to 40.00 °C.
– Enter the desired temperature and
confirm with ENTER.
-5
10 with a measurement time of approx.
*
-5
10 with a measurement time of approx.
*
-4
10 with a measurement time of approx.
*
0 0
Drying
2nd rinsing
1st rinsing
Sample draining
Sample addition
Entry
0 or 1
0 or 1
0 or 1
0, 1 or 2
0, 1 or 2
RA-510M
METTLER TOLEDO