Initial Operation; Installing The Handle Bar; Install/Empty Grass Catchment Basket - Grizzly BRM 4616-20 HA Originalbetriebsanleitung

Initial Operation

Caution! Risk of injury from
rotating blades. Carry out work
on the equipment only when the
blade is switched off and sta-
tionary.
Before starting the equipment, you must
- Remove the Protective Caps
- Install the handle bar
- if necessary, mount the grass collec-
tion box, mulch kit
- Install the starter cord
- Fill with engine oil
- Fill with petrol
- Adjust cutting height if required

Installing the Handle Bar

Caution! When installing
the handle bar, ensure that
the Bowden cables are not
squashed.
1. With a wrench (size 13) remove
bar mounting and nuts (26) on
equipment
2. Attach lower handlebar (4) with
screws and nuts (26) of handle-
bar.
3. Fix the curved handle (1) using
the enclosed screws and the
wing nuts (20) on the lower bar
(4).
4. Fix the Bowden cables to the
bar using the cable clamp (5)
Install/empty grass catchment
basket
Caution: Do not operate the
equipment with the grass col-
lection box or impact protection
installed incompletely. Risk of
injury!
Assemble grass catchment
basket:
1. Insert the strap (27) of the grass
catcher (19) into the notch pro-
vided on the rear side of the lid
(28). Fasten these with washers
and screws.
2. Put the plastic straps of the
base (29) over the grass catch-
er rod and allow the plastic strip
to snap into place in the upper
recesses of the lid.
Fixing the Grass Collection
Box onto the Equipment:
Prior to using the collection box,
the mulch kit must be removed
(see ).
3. Lift up shock protection (6).
4. Hook the grass collection box
(19) into the mounting provided
for this (30) on the rear of the
equipment. .
5. Release the impact protection
(6). It holds the grass collection
box in position.
Dismantling/Empty out the
Grass Collection Box:
6. Lift the impact protection (6) and
remove the grass collection box
(19).
UK
81