Sony LT20-Series Bedienungsanleitung Seite 61

4. Setting the display resolution or direction
(channel A)
One of 0.0005, 0.001, 0.005, 0.01,
–0.0005, –0.001, –0.005, or
–0.01 mm can be chosen.
• With the measuring probe's
spindle pushed in:
+: positive direction
–: negative direction
∗ When set to inches, values are chosen from 0.00002,
0.00005, 0.0002, 0.0005, –0.00002, –0.00005, –0.0002,
and –0.0005.
Note
The resolution cannot be set higher than the resolution set
in step 2.
5. Setting the display resolution or direction
(channel B, 2 channel models)
One of 0.0005, 0.001, 0.005, 0.01, –0.0005, –0.001,
–0.005, or –0.01 mm can be chosen.
• With the measuring probe's spindle pushed in:
+: positive direction
–: negative direction
• When displaying A+B:
If you set the direction of A to "–" the data displayed is
the calculation "–A+B".
The same can be done with B.
Note
• The resolution cannot be set higher than the resolution
• When the addition A+B is chosen the direction for B can
A
6. Selecting the start input terminal (terminals) function
factory-set
Initial settings are now complete for the standard
model.
Pressing
set in step 3.
be selected, but its resolution will be the same as that of A.
(See P60 "6. Terminals I/O".)
: When the peak-hold
function is chosen
setting this terminal to
" L " ( O N ) s e t s t h e
peak-hold value to
the current value and
restarts the storing
procedure.
: With the current value measuring mode
setting this terminal to "L" (ON) stores the
output and display of the Go/No Go
comparison at that point in time.
Note
A t t h i s t i m e , d i s p l a y a n d G o / N o G o
comparison output storage by the DRQ input
for the BCD model and EXT. IN input for the
RS-232C model is invalidated .
.. Basic model → Returns to the measuring state.
MODE
BCD model → Go to section 5-1-2.
RS-232C model → Go to section 5-1-3.
factory-set
53