Power Connection - Denver CRP-717 Bedienungsanleitung

1. This product operates on AC230V~ 50Hz power supply. Plug the
AC power cord into a household outlet AC source.
2. Clock display will flash 0:00 until set to correct time.
This unit is equipped with a battery back-up system, requiring one
DC3V CR2032 lithium battery (not included) to maintain the time
settings and radio presets during AC power outage.
1. Unscrew and remove the BATTERY COMPARTMENT COVER.
2. Install one fresh CR2032 lithium battery into the battery
compartment following the polarity diagram on the BATTERY
COMPARTMENT COVER. Use only the specified size and type
of battery.
3. Replace the BATTERY COMPARTMENT COVER and tighten its
screw.
Note: The unit will operate without a battery installed but your time
& alarm setting and radio presets will be lost and will have to be
reset in the event of power interruption or failure.
IMPORTANT:
Be sure that the battery is installed correctly. Wrong polarity may
damage the unit and void the warranty. For best performance and
longer operating time, we recommend the use of good quality
battery.
BATTERY CARE:
- Use only the size and type of battery specified.
- If the unit is not to be used for an extended period of time,
remove the battery. Old or leaking battery can cause damage to
the unit and may void the warranty.
- Do not try to recharge battery not intended to be recharged; they
can overheat and rupture (Follow battery manufacturer's
directions).
- Do not dispose of battery in fire, battery may leak or explode.
DENVER CRP-717.indd 3

POWER CONNECTION

INSTALLING/REPLACING THE BACK-UP BATTERY
ENG-2
15 11 27 9:40