Elvox RS03 Installations- Und Benutzerhandbuch Seite 23

5 - Description of the LEDs and buttons on the card:
ABBREVIATION
AC Shows whether there is mains power (lit if there is mains voltage)
STPA Displays the status of the STPA input (number 19), if not engaged the LED remains lit, if not used then jumper between terminal
COM and STPA
AP/CH Displays the status of the AP/CH input (number 14), if not engaged the LED remains off
APED Displays the status of the aped input (number 15), if not engaged the LED remains off
STOP Displays the status of the stop input (number 17), if not engaged the LED remains lit, if not used then jumper between terminal
COM and STOP
PHOTO Displays the status of the photo input (number 18), if not engaged the LED remains lit, if not used then jumper between terminal
COM and PHOTO.
ENCM1 Displays the motor 1 encoder input, on steady when the motor is moving at cyclical speed, flashing during slowdown, off with the
motor stopped.
ENCM2 Displays the motor 2 encoder input, on steady when the motor is moving at cyclical speed, flashing during slowdown, off with the
motor stopped.
DL6 Displays the programming status of the travel and of the radio control learning
Buttons in the circuit:
Abbreviation
AP/CH
P2
P3
Preliminary check:
After powering up the control panel the DL6 LED comes on with a series of flashes to indicate the version of the firmware. Check the LEDS for diagnosis of
the inputs, STOP, PHOTO and STPA must be on.
EN
DESCRIPTION
Description
Controls opening and closing the gate
Press to enter travel programming
Press to enter radio controls programming or deletion
21