14
www.electrolux.com
9. DAILY USE
1. Open the water tap.
2. Press the on/off button to activate the
appliance.
• If the display shows the salt refilling
message, fill the salt container.
• If the display shows the rinse aid
refilling message, fill the rinse aid
dispenser.
3. Load the baskets.
4. Add the detergent.
5. Set and start the correct programme
for the type of load and the degree of
soil.
9.1 Using the detergent
A
CAUTION!
Only use detergent
specifically designed for
dishwashers.
1. Press the release button (B) to open
the lid (C).
2. Put the detergent, in powder or
tablets, in the compartment (A).
3. If the programme has a prewash
phase, put a small quantity of
detergent on the inner part of the
appliance door.
4. Close the lid. Make sure that the
release button locks into position.
B
30
20
C
9.2 Setting and starting a
programme
The AUTO OFF function
This function decreases energy
consumption by deactivating automatically
the appliance when it is not operating.
The function comes into operation:
• 5 minutes after the completion of the
programme.
• After 5 minutes if the programme has
not started.
Starting a programme
1. Press the on/off button to activate the
appliance.
2. Close the appliance door.
3. Set the programme and options.
4. Press the OK key, the programme
starts.
If the salt and rinse aid refilling messages
show in the display, the programme will
not start. Press the OK key again to start
the programme.
How to delay the start of a
programme
1. Set the programme and options.
2. Set the delay start
You can delay the start of a programme
from 1 to 24 hours.
3. Press the OK key, the countdown
starts.
If the salt and rinse aid refilling messages
show in the display, the countdown will
not start. Press the OK key again to start
the countdown.
When the countdown is completed, the
programme starts automatically.
Opening the door while the
appliance operates
If you open the door while a programme is
running, the appliance stops. When you