Special Function Button 1; Arc Length / Welding Voltage / Welding Choke; Dial 2 (Right Display); Graphic Display - Jackle ProPuls 330 Betriebsanleitung

Material selection (MATERIAL):
With the left dial (pos. 2), the desired material / gas / wire diameter combination can be selected and confirmed
with the button 'ENTER/ OK' (pos. 12).
All the materials stored in the machine are listed in the table.
The text display (pos. 9) shows the following information (example):
1. Line: Welding process / number
2. Line: Material
3. Line: Wire diameter
4. Line: Gas type / mixture

16.6 Special function button 1

With this button, special functions are possible.
An exact description can be found near the respective functions.

16.7 Arc length / welding voltage / welding choke

V
• Arc length:
• Welding voltage:
• Welding choke:
Repeatedly press the button to select the desired function.
The respective LED illuminates.
The value can be set with the right dial (pos. 8).

16.8 Dial 2 (right display)

With this dial, the respective active parameters arc length / welding voltage or welding choke can be
adjusted.
Furthermore, the functions in the text display (left half of the display) can be changed.

16.9 Graphic display

Display to show all welding functions and parameters.
Operating manual
PULSE
MAT STEEL
¤ 0.8
GAS AR 82%
Special
function
button 1
Possible range from -30% to +30% of the set voltage level in 1% increments.
A value smaller than 0 means a shorter arc.
A value larger than 0 means a longer arc.
V
Shows the voltage currently set.
It can be changed (adjusts welding power) using the left dial.
In the welding process 'MANUAL', the welding voltage can be set between 10V -
38V in 0.1V increments.
Possible range from -30% to +30% in 1% increments
A value smaller than 0 means a 'softer' arc.
A value larger than 0 means a 'harder' arc.
ProPuls 330,400,500
4711
CO2 18%
Page 45