Battery Disposal; Important Recycling Advice - Petsafe PIG20-11041 Gebrauchsanweisung

2. Check your garden to determine any possible damage to the Boundary Wire (e.g. recent digging, aerating, rodent
burrowing, or any other noticeable disturbance in your garden next to the Boundary Wire).
If you still cannot fi nd the break in the Boundary Wire, there are two options for locating it:
Option 1: Contact the Customer Care Centre to purchase a Wire Break Locator that will locate the break in the Boundary Wire.
Option 2: Follow the procedure below:
1. Unplug the Fence Transmitter.
2. Connect both ends of your twisted Boundary Wire to one Boundary Wire Terminal.
3. Measure and cut a Test Wire which is half the length of your total Boundary Wire footage.
4. Connect one end of the Test Wire to the other Boundary Wire Terminal.
5. Locate the halfway point of your boundary and cut the Boundary Wire.
6. Splice the other end of the Test Wire to either side of your Boundary Wire where you cut it
in half.
7. Plug in the Fence Transmitter and check the Loop Indicator Light. If the Loop Indicator Light is
on you can assume the break is in the other half of the Boundary Wire.
8. If the Loop Indicator Light did not come on, you may assume there is a break in this portion of
the Boundary Wire. However, there is a small chance of having more than one break in your
system. Be sure to check both halves of your entire loop.
9. Replace the damaged Boundary Wire with new Boundary Wire.
10. Reconnect the Boundary Wire to the Fence Transmitter.
11. Check the Loop Indicator Light. If the Loop Indicator Light is on, test the system with the Receiver Collar.

Battery Disposal

This device operates on one battery of the type Lithium 3-Volt with 160 mAH capacity. Replace only with equivalent
battery received from calling the Customer Care Centre. For a listing of Customer Care Centre telephone numbers, visit
our website at www.petsafe.net. Separate collection of spent batteries is required in many regions; check the regulations
in your area before discarding spent batteries. Please see page 12 for instructions on how to remove the battery from the
product for separate disposal.

Important Recycling Advice

Please respect the Waste Electrical and Electronic Equipment regulations in your country. This equipment must be recycled. If
you no longer require this equipment, do not place it in the normal municipal waste system. Please return it to where it was
purchased in order that it can be placed in our recycling system. If this is not possible, please contact the Customer Care Centre
for further information.
www.petsafe.net
Ground
Wire
Boundary
Test
Wires Wire
25