Hardware Installation; Connecting The Cables - Conceptronic CH3SNAS Schnellinstallationsanleitung

ENGLISH
3

Hardware Installation

3.1 Installing the Harddisk(s)
1) Slide the front panel up and then pull it off the server to access the drive bays.
2) Insert 1 or 2 SATA 3.5" hard disk drives into the available drive bays until they are
firmly connected to the SATA slot on the server.
3) Replace the front panel onto the server.

3.2 Connecting the cables

1) Plug the AC power adapter to the DC power connector located on the server's rear
panel, and then connect it to your local power supply.
Note: You can attach the provided Cable Hook to the slot to organize the connected
cables on the rear panel of the server.
2) Plug an Ethernet cable to the LAN port located on the server's rear panel, and then
connect it to the network or directly to a computer for configuration.
Note: We advise to connect the CH3SNAS to your DHCP enabled router for easy
configuration. If you connect the device directly to your computer, or to a
network without DHCP server, you need to setup a temporary static IP address
for your computer to configure the CH3SNAS.
See page 10 of the Full Manual (CD-ROM) how to setup a static IP address.
22