Packing List - Epson SR-600 Bedienungsanleitung

CAUTION:
Do not drop, bump, or otherwise subject this product to strong vibration
or impact.
Do not block the openings on this product. They are provided for the
ventilation necessary to ensure reliable operation and protection from
overheating.
Be sure to attach all covers after setup. If they are not attached, foreign
matter may enter this product and cause trouble.
Never clean the product with thinner, benzene, alcohol, or other such
solvent.
Do not use this product with any voltage other than the specified one. It
may lead to fire.
When a power cable for a TM printer is connected, do not short-circuit
its connector pins.
Do not insert fingers or foreign matter into the CD-ROM disk tray or
opening. It may cause fire, shock, or injury.
Never hold this product by the rear cover, the front panel, or the
CD-ROM disk tray. They cannot support the weight of the product, so it
may fall onto the floor.
Make sure that the total power requirements of all devices receiving
power from this product do not exceed the power limitation. See
specifications for more detailed information.
Be sure to use this product with the rear cover and side covers
attached.
Be careful not to cut your finger on any edge of the unit.
Be sure to use EPSON supplied DIMMs, HDDs, CPUs, and KBs.
Do not adjust the LCD angle when the FDD is connected, the CD-ROM
tray is open, or the front key is inserted. Otherwise you may damage the
FDD connector, the disk tray, or the keylock.
To get the latest information about which CompactFlash  card or PCI
board can be used with this product, contact your EPSON dealer.
If you turn off the unit, wait more than 10 seconds before you turn it on
again.

Packing List

❏
Front Key
❏
DM holder
❏
DM cover
❏
User's Manual
SR-600 User's Manual 7
English