Malfunction Causes And Remedies; Storage/Disposal; Storage; Disposal Of The Appliance - Silvercrest SEKU 2000 A1 Bedienungsanleitung

Troubleshooting/Storage/Disposal

Malfunction causes and remedies

The following table will help with localising and remedying minor malfunctions:
Defect
The fl ame replication does
not light up.
The appliance does not heat.
The fan does not run.
The heating is not switched off .
NOTICE
If you cannot solve the problem with the aforementioned methods, please contact Customer Services.
►

Storage/Disposal

Storage

Disconnect the plug if you are not intending to use the appliance for a long period.
Store the appliance at a dry locality.

Disposal of the appliance

Do not dispose of the apliance in your normal domestic waste. This product is subject to
the provisions of European Directive 2002/96/EC-WEEE (Waste Electrical and Electronic
Equipment).
Dispose of the appliance through an approved disposal centre or at your community waste facility.
Observe the currently applicable regulations. In case of doubt, please contact your waste disposal centre.
SEKU 2000 A1
Possible cause
The appliance is not switched on.
The plug is not inserted.
The mains power socket does
not supply voltage
The bulbs are defect.
Switch is not turned on.
Switch is not turned on.
2
Switch is not turned on.
3
Heating level control defective
Switch is not turned on.
Switch 2 is not turned on.
Fan defect.
Thermostat falsely adjusted.
4
Temperature control defect.
4
Solution
Switch the appliance on.
Insert the plug into the
mains power socket.
Check the fuses
Replace the defective bulbs.
Switch on.
Switch on.
2
Switch on.
3
Inform Customer Services.
Switch on.
Switch 2 on.
Inform Customer Services.
Set the thermostat at the
4
required temperature.
Inform Customer Services.
GB
CY
17