Using The Auto Off Timer - Mitsubishi Electric PAR-W21MAA Bedienungshandbuch

3 Using the Auto Off Timer

This timer begins countdown when the unit starts, and shuts the unit off when the
set time has elapsed.
Available settings run from 30 minutes to 4 hours, in 30-minute intervals.
Note:
*1 Weekly Timer/Simple Timer/Auto Off Timer cannot be used at the same time.
*2 The Auto Off timer will not operate when any of the following conditions is in
effect.
The timer is off; the system is in malfunction state; a test run is in progress; the
remote controller is undergoing self-check or remote controller check; the user is
in the process of selecting a function; the user is in the process of setting the
timer; the system is under central control. (Under these conditions, ON/OFF
operation is prohibited.)
<How to Set the Auto Off Timer>
1. Be sure that you are at a standard control screen, and that the Auto Off timer
indicator is visible in the display (at 1).
When something other than the Auto Off Timer is displayed, set it to AUTO OFF
TIMER using the function selection of remote controller (see 6.[4]–3 (3)) timer
function setting.
2. Hold down the Timer Menu button b for 3 seconds, so that the "Set Up" appears
on the screen (at 2).
(Note that each press of the button toggles the display between "Set Up" and
"Monitor".)
3. Press the appropriate Set Time button a as necessary to set the OFF time (at 3).
button 4 to lock in the setting.
4. Press the CIR.WATER
Note:
Your entry will be cancelled if you press the Mode (Return) button 2 before pressing
button 4.
the CIR.WATER
5. Press the Mode (Return) button 2 to complete the setting procedure and return to
the standard control screen.
6. If the unit is already running, the timer starts countdown immediately. Be sure to
check that the timer setting appears correctly on the display.
<Checking the Current Auto Off Timer Setting>
1. Be sure that the "Auto Off" is visible on the screen (at 1).
2. Hold down the Timer Menu button b for 3 seconds, so that "Monitor" is indicated
on the screen (at 4).
• The timer remaining to shutdown appears at 5.
3. To close the monitor and return to the standard control screen, press the Mode
(Return) button 2.
– 13 –
Timer Settings
Timer Settings