Turning On The Power - Mitsubishi Electric PAR-30MAA Installationsanleitung

9. Turning on the power

Make sure that the MA remote controller is properly installed according to the instructions in the Installation Manual and that the indoor and
outdoor unit installation has been completed before turning on the power.
(1) When the power is turned on, the following screen will appear.
Please Wait
10%
Normal start up (indicating the
percentage of process completion)
(2) Main display
After the successful startup, the Main display will appear. The Main display can be displayed in two different modes: "Full" and "Basic."
Refer to section 11 "Initial settings" for how to select the display mode. (The factory setting is "Full.")
Main display in the Full mode
(while the unit is not in operation)
10. Test run <Maintenance password is required.>
(1) Read the section about Test run in the indoor unit Installation Manual before performing a test run.
(2) At the Main display, press the MENU button and select Service>Test run>Test run.
(3) Press the ON/OFF button to cancel the test run if necessary.
(4) Refer to the indoor unit Installation Manual for the detailed information about test run and for how to handle the errors that occur during
a test run.
Note: Refer to section 12 "Service menu" for information about the maintenance password.
11. Initial settings (Remote controller settings)
From the Main display, select Main menu>Initial setting, and make the remote controller settings on the screen that appears.
Initial setting menu
Main/Sub
Clock
Main display
Contrast
Display details
Main menu:
Cursor Page
(1) Main/Sub setting
When connecting two remote controllers, one of them needs to be designated as a sub controller.
[Button operation]
[1] When the F3 or F4 button is pressed, the currently selected setting will appear highlighted.
Select "Sub", and press the SELECT button to save the change.
[2] Press the MENU button to return to the Main menu screen. (This button always brings up the
Main menu screen.)
Notes
· When the power is on for the first time, the Language selection screen will be displayed. Refer
to section 11 (8). Select a desired language. The system will not start-up without language
selection.
· Some models of City Multi cannot have more than one remote controller connected. Refer to
relevant documents (e.g., catalogs) for usage compatibility.
Fri
Room
Cool
Set temp.
Mode Temp.
Main display in the Full mode
(while the unit is in operation)
Initial setting menu (1/2)
· Main/Sub
· Clock
· Main display
· Contrast
· Display details
-Clock
-Temperature
-Room temp.
-Auto mode
Fri
Notes
· When connecting two remote controllers, be sure
to designate one as a main and the other as a sub
Auto
controller. Refer to section 11 "Initial settings" for
how to make the Main/Sub setting.
· Refer to the Instructions Book for the icons on the
Fan
display.
Initial setting menu (2/2)
· Auto mode
· Administrator password
· Language selection
– 10 –
Main/Sub
Main / Sub
Select:
Cursor