Specifications - Hitachi FM 8 Bedienungsanleitung

English

SPECIFICATIONS

Voltage (by areas)*
Power input
No-load speed
Collet chuck capacity
Main body stroke
Weight
*Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) Parallel Guide Ass'y ................................................... 1
(2) Template Guide .......................................................... 1
(3) Wrench ........................................................................ 2
(4) Screws (for mounting the nameplate guide) ........... 2
One scale, one knob screw, two wing bolts, and two lock
springs are packaged together with the standard
accessories (2), (3), and (4) mentioned above.
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES-sold separately
1. Feed Screw Assembly
2. Trimmer Guide Assembly
3. Chuck Sleeve
4. Collet
8mm, 6.35mm, 6mm
5. Dust Collector set (Fig. 21Z)
Optional accessories are subject to change without notice.
APPRICATIONS
Woodworking jobs centered on grooving and
chamfering.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
6
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
550W*
27000/min
8mm or 6.35mm(1/4") or 6mm
52mm
2.3kg (without cord and standard accessories)
8 × 6 Chuck Sleeve
8 × 6.35 Chuck Sleeve
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool
will start operating immediately, which could cause
a serious accident.
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
4. Attach the power tool to the holder
Ensure that the power tool is securely fixed to the
holder.
CAUTION
If it is not, it will be very dangerous.
The power tool can be securely fixed by tightening
the holder's knob bolt. (Fig. 1)
5. Installing the handle knob
To install the handle knob, screw it into the holder
fixing hole securely. (Fig. 1)
MOUNTING AND DISMOUNTING BITS
1. Mounting Bits
(1) After fully inserting the bit into the collet chuck
hole, firmly tighten the collet chuck with the
accessory wrenches, as shown in Fig. 2.
CAUTION
Ensure that the collet chuck is firmly tightened after
inserting the bit. Failure to do so will result in
damage to the collet chuck.
(2) Use a proper bit which has the same diameter as
the collet.
2. Dismounting Bits
To dismount the bit, follow the mounting procedures
in reverse, starting with loosening the collet chuck
with the accessory wrenches.
HOW TO USE THE ELECTRIC ROUTER
1. Adjusting the cutting depth
(1) Adjusting the cutting depth with the scale:
1 Loosen the knob to have the scale move freely.
(Fig. 3)
2 As shown in Fig. 4 loosen the knob ass'y, push
downward on the handles until the bit lightly
contacts the sruface of the material, and reclamp
the knob ass'y. This preliminary setting is called
"cut 0 (zero)".
3 Next, read the scale on the holder.
Pull the scale up to the desired cutting depth,
then tighten the knob (Fig. 5).