Switching On The Machine - Corghi EM 7240 Betriebsanleitung

SWITCHING ON THE MACHINE

Connect the power supply cable (A, Fig. 9d) supplied with the machine from the external
electrical panel located on the rear side of the wheel balancer body to the mains.
Switch on the machine using the switch on the rear side of the body (B, Fig. 9d).
9d
The wheel balancer performs a checking test (all the LEDs illuminate), and if no faults are
detected, a beeper sounds and the cycle status initially active is displayed, as follows:
- Active balancing mode: dynamic (DYN).
- Values displayed: 000 000.
- Grams displayed in units of 5 ( or 1/4 of an ounce).
- Active sensor rounding-off (in the version with digital sensor).
- Default geometric values: width = 5.5", diameter = 14", distance = 150 mm.
Now the operator can set the data of the wheel to be balanced or select one of the pro-
grams available.
72 EM 7240 Operator's manual