Trimming The Bikini Line With The Precision Trimmer And Trimming Comb - Silvercrest SBT 3.6 D2 Bedienungsanleitung

6) When you are finished with the treatment, push the on/off switch
direction to switch off the appliance.
7) Clean the epilator head
NOTE
► If the epilator head
, please contact the service department (see chapter Service). Please
head
have the IAN number ready (see operating manual cover).
Trimming the bikini line with the precision trimmer and
trimming comb
Use the precision trimmer
1) Start by removing any other attachment from the hand element
Fit the precision trimmer attachment
grooves in the attachment match up with those on the back of the hand element
2) Push the precision comb
until it clicks into place.
3) You can vary the cutting length to any one of the five settings. To do this, press on
the grooved area
into the housing. Then push the precision comb
corresponds to the desired length. Use the cutting settings on the precision comb
as an orientation aid as well as the following table:
Setting
1
2
3
4
5
4) Push the on/off switch
5) Hold the skin tight with one hand.
6) Place the appliance perpendicular to the skin and, without exerting any pressure, move
it against the direction of the hair growth. The flat side of the precision comb
always be set against the skin to achieve an even cut.
7) If a lot of hair has accumulated in the precision comb
blow or shake the hair out.
8) When you are finished with the treatment, push the on/off switch
direction to switch off the appliance.
│ GB │ IE │ NI
■ 10
as described in the section "Cleaning and Care".
is damaged, do not use it any more! To order a new epilator
with the precision comb
onto the hand element
with its side rails onto the two grooves on the appliance
on the precision comb
Hair length after cutting
approx. 3 mm
approx. 5 mm
approx. 7 mm
approx. 9 mm
approx. 11 mm
in the direction of the attachment.
to trim your bikini line.
so that the two
so that the locking catch
to the cutting length position that
, remove the comb and
in the opposite
, if required.
.
is pushed
must
in the opposite
SBT 3.6 D2