Sleep Function; Setting The Station - Silvercrest SWEP 500 A1 Bedienungsanleitung

Sleep function

You can activate the sleep function via the
time of up to 90 minutes in ten-minute steps, after which the radio will auto-
matically turn itself off. To do so, first switch the radio off.
SNOOZE
• Press the
90 (for 90 minutes) will appear.
SNOOZE
• Press the
the sleep time in 10 minute steps.
• Either select a sleep time (the sleep symbol
SNOOZE
or press
The sleep time is now switched off.

Setting the station

• Select the required frequency band (FM, MW, LW or SW), using the
frequency select button.
The corresponding abbreviation will appear on the screen.
UP
• The and
• If you keep
station search will start.
• The search stops as soon as a station with sufficient signal strength is
found.
Setting the MW band
Since the radio transmitter systems differ from one country to another,
you should make the appropriate setting via the reception range setting:
• With the radio switched off, press the button
select, using the buttons
as per the following table:
button. The symbol for the sleep function
button repeatedly until 90 is displayed to count down
again until 00 appears on the screen.
DOWN
buttons can now be used to set the desired frequency.
UP DOWN
or pressed for about three seconds, the automatic
UP
resp.
SNOOZE
button. You can set a
MODE
DOWN
, the appropriate reception range
- 25 -
remains on the screen)
six times and then
and