Handling and use
GB
Switching on and off
Initial operation
10
This section provides you with important information on handling and using the device.
After connecting the device to the power supply, press the POWER button
switch on the device. The operation LED
button again to switch off the device. The LED indicator goes out. To preserve the
environment and for reasons of safety, you should disconnect the mains adapter
when the device is not in use.
If the device does not register any microphone signal for two hours, it will automati-
cally switch into standby mode. Any microphone signal after this will not reacti-
vate the device. To switch the device back on, press the POWER button
In standby mode, there will be no output of the connected audio signal from the
accompanying music source.
When the device is switched off, the connected audio signal from the accom-
panying music source will continue to be transmitted to the output of the con-
nected device.
♦
Set the volume control for the accompanying music MUSIC VOL
middle setting – you will notice a click.
♦
Switch on the television and any connected amplification device and set
these to a moderate overall volume level.
♦
Turn the microphone controllers MIC1
ECHO control
♦
Insert the supplied karaoke DVD
♦
Switch the on/off switch for the microphone signal
being used to the ON position and start singing. Turn the corresponding
microphone control
with the volume ratio between the accompanying music and your singing.
To adjust this ratio, you can also use the volume control for the accompany-
ing music MUSIC VOL
accompanying music. Turn the dial anticlockwise to decrease the volume.
♦
Set the desired volume on the television or amplifier.
above the button lights up. Press the
anti-clockwise as far as they will go.
and start playback.
and/or
slowly to the right until you are happy
. Turn this dial clockwise to increase the volume of the
and MIC2
and also the
for the microphone
to
twice.
to the
SKES 2 A1