Troubleshooting - Silvercrest SPBS 5000 B2 Bedienungsanleitung

Troubleshooting

A connected device is not charging.
♦ Press the ON/OFF button
♦ The power bank's battery is empty . Charge the battery .
♦ No connection to the device . Check the connection .
♦ The power bank can be used for end devices that require a charging current
of no more than 2,1 A . If the connected end device requires a current of
more than 2,1 A, the power bank will switch itself off immediately after being
switched on with the ON/OFF button
suitability for your end device on the basis of the technical data of your end
device .
The power bank will not switch on.
♦ The power bank has switched itself off automatically due to overloading . You
need to charge the power bank for a short while with a USB mains adapter
before you can switch the power bank back on .
The power bank's battery is not charging via the solar panel.
♦ Check that the solar panel
NOTE
► If the above-mentioned solutions do not resolve the problem, please contact
Customer Service (see chapter Service) .
SPBS 5000 B2
briefly to start the charging process .
. In this case, check the power bank's
is receiving sufficient sunlight .
GB │ CY │ 13 ■