Preparation For Installation - Olsberg 14/513 Anleitung

Preparation for installation

OLSBERG electrical appliances conform to valid
safety regulations.
The installation of the day-acting element must only
be carried out by a competent electrician.
• Make sure the heater is switched off. To do this,
switch off the power supply to the charge and dis-
charge circuits.
Caution! Even if the main circuit breakers are
switched off, some terminals carrying
on-peak current, especially terminals
A1/Z1 and A2/Z2 can still be live.
• Also read the Instruction Leaflet supplied with the
storage heater.
• Remove air-outlet grille:
for appliances with stop screw (Fig.1):
Remove stop screw for air-outlet grille on the left
side of the appliance, push air outlet grille to the
left and take off to the front.
for appliances without stop screw (Fig.2):
Remove fixing screws of the air-outlet grille on the
left and right side of the appliance, take off air-
outlet grille.
• Unscrew left and right panel.
• Only for appliances 14/56:
Remove the front panel.
12
Fig. 1 Stop screw for air-outlet grille
Fig. 2 Fixing screw for air-outlet grille