Set The Boundary Width And Test The Receiver Collar - Petsafe PIG19-15394 Gebrauchsanweisung Und Trainingsanleitung

STEP 6
Set the Boundary Width and Test the
Receiver Collar
With the Boundary Wire in place and properly connected, it is time to set the Pet Boundary Width and test the system.
The Receiver Collar should not be on your dog when the system is tested.
Note: The Receiver Collar is waterproof, which can make the tone hard to hear.
The flashing light indicates the Receiver Collar is delivering Static Stimulation. If you have difficulty
hearing the warning tone, use the flashing light to identify the Boundary Width. To best utilize the
automatic Run-Through Prevention feature, the containment Boundary Width should extend at least
2 m - 3.5 m on each side of the Boundary Wire (total Boundary Width of 4 m - 7 m).
1. Ensure the Supplied Power Adaptor is plugged in to the Fence Transmitter and the power light and
Loop Indicator Light are turned on.
2. Set the Boundary Width Control Switch (located on the side of the Fence Transmitter) (6A) to the
A, B, or C setting based on the total length of
Boundary Wire used. Setting B is used for most
properties. The following table indicates the
proper setting.
3. The Boundary Width is adjusted using the
transmitter's Boundary Width Control knob. Turn
the knob anti-clockwise until the alarm sounds and
the Loop Indicator Light is no longer lit. Turn the knob clockwise and increase by 2 numbers. The alarm should turn OFF and
the light should turn ON.
The Receiver Collar should not be on your dog when the system is tested. Your pet may receive an
unintended stimulation.
4. Install the battery in the Receiver Collar. To identify the
Warning and Static Stimulation Zones make sure the
Receiver Collar is set at level 5 (see Step 5).
5. Test the Boundary Width of the system by selecting a
section of straight Boundary Wire that is at least 15 m.
Start inside the centre of the Pet Area.
6. Place the Test Light Tool Contacts on the Contact Points
of the Receiver Collar (6B, 6C). Hold the Receiver
Collar at your dog's neck height with the Contact Points
pointing up (6D) and the PetSafe
Wire. Slowly walk toward the Boundary Wire until you hear
the warning tone (6E). When you hear the warning tone,
you have identified the Boundary Width distance (Static
Stimulation Zone). Two seconds after the warning tone, the
Test Light will begin to flash. The flashing light indicates the
Receiver Collar is delivering Static Stimulation. If you have
difficulty hearing the warning tone, use the flashing light to
identify the Boundary Width. To avoid having the Receiver
Collar go into Over stimulation Protection mode, walk back
into the Pet Area until the toning or flashing stops. If the
Receiver Collar does not tone at the desired range, adjust
the Boundary Width Control knob to obtain the desired
range. Turning the Boundary Width Control knob clockwise
increases the Boundary Width while turning it anti-clockwise
decreases it (6F). Repeat this process as needed until the
Receiver Collar tones between 2 m - 3.5 m from the Boundary
Amount of Wire
Greater than 732 m
Up to 396 m
396 to 732 m
6B
® logo facing the Boundary
www.petsafe.net
Setting
A
B
C
Test Light Contacts
6D 6E
6A
6C
Boundary
Wire
15