Controller Functions; Troubleshooting - Carrera RC 370184001 Jeep Trailcat Montage- Und Betriebsanleitung

• When changing from the first battery to
the second battery, you must stop run-
ning for at least ten minutes. At the next
change, a pause of at least 20 minutes is
absolutely essential.
• Avoid constant motor operation.
• If the car switches itself off several times
one after another, the battery is dead.
Please recharge the battery.
• To switch off after use, follow the steps
in the reverse order.
• After use, remove or disconnect the bat-
tery. Always recharge the battery after
use to prevent its becoming deep dis-
charged. After use, the battery must be
allowed to cool down for at least 20 min-
utes before it can be fully recharged.
• Always keep the rechargeable battery
stored outside the vehicle.
• Clean the Carrera RC car after use.

Controller functions

Full Function
10
You can steer the car in any direction using
the joysticks:
Joystick on left: forwards/backwards
Joystick on right: left/right
11 The LED on the controller lights as soon
as you move one of the two joysticks up or
down, left or right.
12 If you do not touch one of the joysticks, the
LED is not lit, irrespective of whether the ON/
OFF switch is set at ON or OFF.

Troubleshooting

Problem: Car does not move.
Cause: Either the switch on the controller or
the car is set to OFF.
Solution: Switch on.
Cause: There is no rechargeable battery in
the car or the battery is too weak.
Solution: Insert charged battery.
Cause: The car has come to a stop at an ob-
stacle.
Solution: The voltage surge protector has
switched the car off. Turn the ON/OFF switch
on the car to OFF, then back to ON, and place
the car on a clear surface.
Cause: The battery or rechargeable battery
in the transmitter or model is too weak.
Solution: Insert new battery or recharged
battery.
Cause: When it was last used, the model was
not switched off, and the battery is dis-
charged.
Solution: Please recharge the battery.
Cause: The vehicle is very warm.
Solution: Switch both car and controller off
and allow the car to cool down for about 30
minutes.
Problem: Car cannot be controlled.
Cause: Vehicle starts moving unintentionally.
Solution: First turn on the vehicle, only
then the transmitter.
Errors and changes excepted
Colours / final design – changes excepted
Technical changes and design-related changes excepted
Pictograms = symbolic photos
11
ENGLISH
5 6 7