Inserting The Batteries - Carrera RC 370184001 Jeep Trailcat Montage- Und Betriebsanleitung

Charging the rechargeable battery
via computer
2 Take care only to charge the lithium ion
battery supplied with the lithium ion charging
unit (USB charger cable) also supplied. If you
attempt to recharge the battery with any other
lithium ion battery charger or any other type
of charger, this may result in serious damage.
You can recharge the rechargeable battery
with the respective USB charger cable from a
USB port of a computer:
• Connect the USB charger cable with the USB
port of a computer . The LED on the USB
charger cable lights green and indicates that
the charger is correctly connected to the
computer. Place the rechargeable battery in
the charging cradle on the USB cable . The
LED on the USB charger cable lights red to
indicate that the battery is being charged.The
USB charger cable is so designed that re-
versed polarity is not possible.
• It lasts about 90 minutes to recharge a dis-
charged (NOT a deep-discharged) battery.
When the battery is fully charged, the LED
display on the USB charger cable lights
green again.
Note: when delivered, the lithium ion re-
chargeable battery contained is already
part-charged, so the first charging opera-
tion will not last so long.
Always recharge the battery after use to
prevent its becoming deep discharged.
After use, the battery must be allowed to
cool down for at least 20 minutes before it
can be fully recharged. Failure to observe
thispause may damage the battery. Re-
charge the battery occasionally (suggest-
ed every 2–3 months).
Failure to treat the battery as described
above can lead to its becoming defective.
ENGLISH
Installing the rechargeable battery
3 Using a screwdriver, remove the cover of
the battery compartment in the Carrera RC car.
Place the Carrera RC battery in the vehicle.
Ensure the polarity is correct. Replace the
compartment cover using a screwdriver.

Inserting the batteries

4 Open the battery compartment with a
screwdriver and insert the batteries in the re-
mote control. Ensure the polarity is correct.
Replace the compartment cover using a
screwdriver.
Now you can drive the car
The Carrera RC car and the remote control
are bound as a factory setting.
5 1. Switch the car ON at the ON/OFF
switch. The LED on top of the car will flash
rhythmically.
6 2. Switch on the controller. The LED on
top of the controller will flash rhythmically.
After a few seconds, the LEDs on the car and
on the controller will light continuously, mean-
ing the bind has been made.
Adjusting the steering
7
If the Carrera RC vehicle is found to pull to-
wards the left or right while moving, use the
adjuster control shown in the illustration to
adjust the car's track precision.
Let's practise!
Warning! This vehicle reaches high
8
speeds! Practice on an empty surface at
least 2.5 metres (8.2') square. When first
starting, be very careful when operating
the gas pedal.
9 Now it's time to practise! Set up a Carrera
RC vehicle racing track in a large empty area,
using cornerposts, empty cans, or similar ob-
jects. The basic technique to adopt when oper-
ating a Carrera RC is to drive fast on the straight
sections and to slow down in the curves.
10