Electrical Installation - Siko SG62 Originalmontageanleitung

SG62
Installation
Fig. 4: Wire accommodation with thread

4.2 Electrical Installation

Destruction of parts of equipment and loss of regulation control
WARNING
` All lines for connecting the absolute encoder must be shielded.
` Do not disconnect or close live connections.
` Perform wiring work in the de-energized state only.
` Use strands with suitable ferrules.
` Prior to switching on check all mains and plug connections.
` Switch on operating voltage together with the downstream electronics
Basically, all connections are protected against external interference.
NOTICE
Choose a place of operation that excludes inductive or capacitive inter-
ference influences on the absolute encoder. When mounting the system-
keep a maximum possible distance from lines loaded with interference. If
necessary, provide additional installations including screening shields or
metallized housings.
Admissible power input
NOTICE
Supply for the absolute encoder shall be sized sufficiently. The voltage val-
ues are a function of the device design and can be referred to in the tech-
nical data in chapter 9.
Pin configuration of the potentiometer without transducer
Voltage supply ≤ 30 V DC, load capacity < 1 W at 70 °C
SG62 · Date 20.11.2015 · Art. No. 88572 · Mod. status 358/15
1
2
3
unit (e. g., control unit).
English
Wire accommodation
1
Lock nut
2
Setting nut
3
23