Silvercrest SKM 500 B1 Bedienungsanleitung Seite 118

NOTE
► Disconnect the holder with mixing knife
► Remove the small Philips screw from the underside of the holder with mixing
knife
► Rotate the blender
the symbol
the holder
► Remove the sealing ring
with a flat, blunt object (e.g. made from wood) and then carefully guide
the sealing ring
Never use sharp or pointed objects for removing the sealing ring
These can damage the sealing ring
To assemble, place the sealing ring
the blender
is pointing at the symbol
the arrow
screw back in again.
■ Only clean the motor block
cutting knife
■ Clean the holder with mixing knife
dishwater. Afterwards, rinse all parts with clean water so that no detergent
residue remain on the parts.
■ Clean the cutting knife
shredding disk
disc
drive shaft adapter
lid
parts with clean water so that no detergent residue remains on the parts.
–
■ Dry all parts thoroughly before re-using the appliance.
SKM 500 B1
.
until the arrow
on the holder
.
over the knife.
onto the holder
on the holder
is pointing at the symbol
with a damp cloth. Dry everything properly before re-using it.
, the kneading knife
, the grating disk
, the lid with pusher
, the blender
and the dough scraper
You can also clean these parts in the dishwasher! If possible, place the
parts in the top basket of the dishwasher. Ensure that the parts are not
trapped in any way.
from the blender
on the blender
. The blender can then be released from
from the holder: Slightly lift the sealing ring
and therefore cause leaks!
back into the holder
so that the arrow
. Rotate the blender
. Then screw the small Philips
, the power cord and the knife guard for the
and the sealing ring
, the disk adapter
and the cutting disk
, the mixing bowl
, the blender closure
in warm dishwater. Afterwards, rinse all
for cleaning!
is pointing at
!
and place
on the blender
until
in warm
, the
, the emulsifying
, the drive shaft , the
, the blender
115
GB