Troubleshooting - Comfee MPS1-07CRN1 Gebrauchsanweisung

Unit idle for a long time
– Remove the rubber plug at the back of the unit and attach a hose to drain outlet. Place the open
end of the hose directly over the drain area in your basement floor (▸ P. 9, item 11).
– Remove the plug from the bottom drain outlet, all the water in the bottom tray would drain out
(▸ P. 9, item 12)
– Keep the appliance running on [FAN] mode for half a day in a warm room to dry the appliance
inside and prevent mold forming.
– Stop the appliance and unplug it, wrapped the cord and bundle it with the tape. Remove the
batteries from the remote controller.
– Clean the air filter and reinstall it.

Troubleshooting

If something stops working...
DANGER!
Danger of death!
Improper repairs can result in the product functioning unsafely. This endangers yourself
and your environment.
Malfunctions are often caused by minor faults. You can easily remedy most of these yourself. Please
consult the following table before contacting the OBI store. You will save yourself a lot of trouble
and possibly money too.
Fault/malfunction
Unit does not start when press-
ing on/off button
Not cool enough
Noisy or vibration
Gurgling sound
Cause
P1 appears in the display win-
dow?
Room temperature is lower
than the set temperature.
(Cooling mode)
The windows or doors in the
room are not closed.
There are heat sources inside
the room.
Exhaust air duct is not connect-
ed or blocked.
Temperature setting is too
high.
Air filter is blocked by dust.
The ground is not level or not
flat enough.
The sound comes from the
flowing of the refrigerant inside
the air-conditioner.
Troubleshooting
Remedy
Drain the water in the bottom
tray.
Reset the temperature.
Make sure all the windows and
doors are closed.
Remove the heat sources if
possible.
Connect the duct and make
sure it can function properly.
Decrease the set temperature.
Clean the air filter.
Place the unit on a flat, level
ground if possible.
It is normal.
GB
61