Enabling Wifi Signal For Optional App (All Except Cfx28 And Cfx65Dz) - Dometic CFX28 Bedienungsanleitung

Operation
7.7 Enabling WiFi signal for optional app
(all except CFX28 and CFX65DZ)
The cooler can be controlled via WiFi using an app that you can install on a
compatible device. The app has control, display and alarm functions.
For further information go to the Dometic website for your country (see back page).
Note that the app may not be available in your country.
The WiFi name of the compressor cooler begins with"CFX". The preset password is
"00000000". You can change the WiFi name and password individually.
Switching the WiFi signal on or off
➤ Press the "SET" button (fig. 3 4, page 3) five times.
➤ Use the "UP +" (fig. 3 7, page 3) and "DOWN–" (fig. 3 6, page 3) buttons to
switch the WiFi signal on or off.
✓ The desired setting appears in the display for a few seconds. The display flashes
several times and then the current temperature is displayed again.
I
NOTE
• The default setting for the WiFi transmitter is off. For first time use and
whenever power to the device is interrupted, switch on the WiFi
transmitter to use the app.
• The WiFi transmitter uses a small amount of power. For optimal
energy performance switch the WiFi transmitter off if it is not being
used.
Resetting the WiFi to factory settings
In case you have personalized the WiFi settings of your cooling device using the WiFi
app and forgotten your password, you can reset to the factory settings as follows:
➤ Press the "SET" button (fig. 3 4, page 3) five times.
➤ Hold the "UP +" (fig. 3 7, page 3) button for at least five seconds.
✓ In both displays "rES" will blink several times before returning to the previous dis-
play.
✓ The WiFi settings have been reset to factory settings.
For additional information visit the Dometic website from which you downloaded
the app.
20
CFX28 – CFX65DZ
EN