Assembling - Gude GTB 13 Originalbetriebsanleitung

7. Assembling

Assembling and Cleaning
Carefully unpack the drill and all the parts and compare against the list below. Do not throw away the carton
and wrapping until the drill press is completely assembled.
Any worked surface is treated with protective coating to protect the machine against moisture. Remove the
coating using a soft cloth wetted with kerosene or WD-40 agent. Never use acetone. petrol or solvents for
CLEANING.
Parts Fig. 1
1 - Motor assembly
2 - Column
3 - Service instruction (manual)
4 - Tapered drift
5 - Bench crank
6 - Screws/bolts
7 - Chuck and chuck key
8 - Bench
9 - Base plate
Fig. 1
Warning: If a part is missing or found damaged. do not connect the drill to the voltage source until the missing
or defective part is replaced and the assembly completed.
Fig. 2
22
10 - Stems/advancement lever
11 - Column lock lever
12 - Top knob
13 - 2 hex-wrenches & cotter
Assembly tooling:
- Monkey wrench
- Screwdriver*
- Hammer and a piece of wood
Fig. 1