Operating Your Appliance - Beko HCA62320W Handbuch

Operating your appliance

3
The hood is designed for suction of fumes while
preparing meals. The device can be operated in
two modes:
As extractor: vapors are removed outside
the room by means of a venting pipe. The venting
pipe is not available with the device and must be
purchased separately.
A
Use the shortest vapor discharging
pipe possible.
The venting pipe shall have the
A
smoothest inner surface as possible
(it is not recommended to use pipes
of type spiro).
A
Use a pipe with as few bends as
possible (bending angles should not
be greater than 90 degrees).
It is not recommended to apply
A
section changes of the pipe (larger
to smaller e.g. air outlet Ø150 mm to
air outlet Ø120mm).
As absorber: vapors are cleaned of grease
and odors before they are returned to the room
through the grille on the upper chimney cover. If
the hood shall work as an absorber, it is necessary
to install an active carbon filter (Fig. 10). The
carbon filter is not standard equipment; it must be
purchased from a vendor.
10 / EN
Hood / User Manual