Troubleshooting; Cleaning And Maintenance - Powerfix Z31385 Bedienungsanleitung

Slide the function switch
locate metal pipes etc.
Slide the function switch
locate power lines etc.
Keep the detector at a distance from metals and from
live cables.
Afterwards, press and hold down the PUSH button
Point the measuring head
desired place on the wall while holding down the
PUSH button.
Move the device slowly over the wall surface.
Note: Ensure direct contact between the measuring
head and the wall.
1
Once the device locates metal or power lines, the red
LED flashes. A beep is also heard. The closer you
2
move the device to metal or power lines, the faster the
red LED flashes and the more frequently the beep
2
is heard. If there are power lines or metal in the imme-
diate vicinity, the red LED
The beep sounds continuously.
Release the PUSH button
measurement.

Troubleshooting

= Error
= Problem
= Solution
No beep is heard when metal or power
lines are in the immediate vicinity.
The batteries are flat.
Change the batteries (see "Inserting / changing the
batteries").

Cleaning and Maintenance

Clean the outside of the device only with a soft,
slightly moist cloth. Never use liquids or cleaning
agents, as they may damage the device.
10 GB/IE
to "METAL" in order to
3
to "VOLTAGE" in order to
3
directly towards the
1
lights up permanently.
2
in order to stop the
4
.
4