Adjusting The Awning - Dometic PerfectRoof PR4500 Bedienungsanleitung

Adjusting the awning

7 Adjusting the awning
7.1 Resetting the outer limit
The optimum outer limit of the awning is set by default. Over time, the setting
for the outer limit can become incorrect. The awning then fails to extend fully
or far enough so that the fabric hangs down.
Reset the outer limit as follows:
➤ Briefly press the
✓ The awning extends all the way.
➤ Press the
✓ The awning briefly moves twice, indicating the setup mode.
➤ Press and hold the
rect outer limit.
The fabric should lie loosely on the arms. Later on the back impulse after
extending the awning will apply the tension to the fabric.
➤ Press the
✓ The awning briefly moves twice, which confirms the new setting.
I
NOTE
If the awning does not briefly move twice, you need to reset the
motor and the remote control, see chapter "Resetting the motor
and remote control" on page 45.
42
button.
and buttons simultaneously for about 6 seconds.
or button until the awning moves to the cor-
button for about 3 seconds.
PR4500
EN