Sharp PG-A10X-SL Serviceanleitung Seite 26

PG-A10X
PG-A10X-SL
AN-A10T
No. Adjusting point
15 DTV Color
saturation
adjustment
16 DVD Tint adjust-
ment
17 DVD Color
saturation
adjustment
18 Sample hold
pulse phase
checking
19 RGB tone
reproduction
adjustment
20 White balance
checking
21 Color-related
performance
checking
22 Video-related
performance
checking
23 RGB perform-
ance checking
Adjusting conditions
1. Select the following group
and subject.
Group : DTV
Subject : Color
1. Select the following group
and subject.
Group : DVD
Subject : Tint
1. Select the following group
and subject.
Group : DVD
Subject : Color
1. Feed the XGA 75-Hz black
signal.
2. Select the following group
and subjects.
Group : OUTPUT3
Subject : GCK-PHASE
1. Feed the SMPTE pattern
signal.
1. Use the adjustment condi-
tions in the item 9 for RGB
input and item 10 for sRGB
input.
1. Feed the color bar signal.
1. Feed the monoscope pat-
tern signal.
1. Feed the RGB signal.
Adjusting procedure
1. Check the fixed value.
Color : 13
1. Check the fixed value.
Tint : 8
1. Check the fixed value.
Color : 10
1. Check the fixed value.
Fixed Value : 8
1. Make sure the 100% and 95% white as well as the
0% and 5% black gradations are visible.
Check that there is no deviation of white balance with
the monitor.
1.Select L1 of the process mode. Operation check of
Color and Tint.
1.Select L2 of the process mode. Operation check of
Picture, Bright and Sharpness.
1.Select L4 of the process mode. Operation check of
Picture, Bright,Red, Blue, Clock, Phase, H-POS and
V-POS.
26