Master/Slave Operation; Connection With The Mains; Connection Between Devices; Operation - Futurelight PRO Slim PAR-12 MK2 HCL Bedienungsanleitung

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master
device. On the rear panel of the device you can find an XLR jack and an XLR plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Set the desired effect for the master-device, as described in chapter Control Board. Set the DMX address
d001 or A001 for all slave-devices.

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
The device is equipped with a lockable power input connector. Plug in the power cord and turn it to the right
until it locks. Plug the power cord into a grounded electrical outlet that matches the rated voltage of the
machine.

Connection between devices

On the rear panel, there is a socket (Power Out). Connect the output with the mains input of the next fixture
until all fixtures are connected.
Please note: A maximum of 8 devices may be linked together. After every 8 devices,
the fixtures must have a renewed connection with the power mains.

OPERATION

After you connected the spot to the mains, the FUTURELIGHT PRO Slim PAR-12 MK2 HCL starts running.
The display lights up and you can choose the desired mode via the buttons MENU, ENTER, UP and DOWN.
The device has two operating modes. It can be operated in stand-alone or in DMX-controlled mode.

Stand-alone mode

In the stand-alone mode, the FUTURELIGHT PRO Slim PAR-12 MK2 HCL can be used without controller.
Disconnect the FUTURELIGHT PRO Slim PAR-12 MK2 HCL from the controller.
International
L
N
23/28 00101792, Version 1.0