Connection With The Mains; Operation; Display And Function Buttons - EuroLite TMH-155 Bedienungsanleitung

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the effect to the mains, the TMH-155 starts running. During the Reset, the motors are
trimmed and the device is ready for use afterwards.
Turn the focus-screw next to the objective-lens for adjusting the focus in order to obtain a sharp projection.

Display and function buttons

Press the Function Button and select from the functions F1 – F4.
F1 - Pan Reverse
With this function you can reverse the Pan-movement.
• Press the Function button and select „F2".
• Press the Up button to select "y" if you wish to enable this function or press the Down button to select "n"
if you don't.
F2 - Tilt Reverse
With this function you can reverse the Tilt-movement.
• Press the Function button and select „F2".
• Press the Up button to select "y" if you wish to enable this function or press the Down button to select "n"
if you don't.
International
L
N
29/63 51786410_V_1_2.0.DOC