Locations And Functions Of Parts - Sony BC-1WD Bedienungsanleitung

Locations and Functions of Parts

Front Panel
1 POWER switch and lamp
2 LIFE button and display
LIF E
Ah
ON
RE FR ES
OF F
OF F
B A T T E R
Y C H A R
G E R B
3 REFRESH OFF button
1 POWER switch and lamp
Turn this switch ON to supply the power and the
associated lamp will light up. Once the power is
turned ON, the battery packs in the battery pack
insertion section will be charged in order from 1 to 4.
2 LIFE button and display
Press this button when desiring to determine the life of
the battery pack. This function works only in regard to
the battery pack in insertion section 4. After inserting
a battery pack into section 4, press this button and the
indication "OP" will appear on the display.
Subsequently, the results of the available battery
capacity measured will appear on the display.
3 REFRESH OFF button
Press this button and it will light up and charging will
begin immediately without automatic refresh
discharging. Press this button to alternate between the
auto refresh mode (button OFF) and the refresh OFF
mode (button ON). After all of the battery packs
inserted in sections 1 through 4 have been charged
once, this button automatically goes out and returns the
charger to the auto refresh mode.
4 Battery pack insertion section and charge lamps
1 to 4/LIFE
Insert the NP-1/1A/1B battery packs.
The LIFE indication shows the action of the LIFE (life
judgement) function only of the battery pack inserted
in section 4. The status of that battery pack is shown
16
H
C -1 W D
4 Battery pack insertion section and
charge lamps 1 to 4/LIFE
Front and rear panels of the BC-1WD/1WDCE
Rear Panel
5 Ground terminal
U
in the following manner by lamps flashing and lighting
in red and green.
For the indications of the lamps during charging, see
"Indications of the charge lamps."
5 Ground terminal
Connect to a ground wire when necessary.
6 AC IN connector
Used to connect the unit to an AC outlet using the
supplied AC power cord.
7 Plug holder
Secures the AC power cord so that it will not come
loose from the unit.
When removing
-AC IN
7 Plug holder
6 AC IN connector
Plug Holder