Engine Oil Level; Hydraulic System - Jacobsen G-Plex II Sicherheits Und Bedienungs Anleitung

GB

ENGINE OIL LEVEL

Damage to engines due to improper maintenance or
use of incorrect oil quality and/or viscosity is not
covered by the engine warranty (refer to the engine
operator's manual for crankcase capacity and
recommended oil grade and weight).
Unit must be on a level surface to obtain an
accurate oil level reading.
The oil level must be kept between the two marks
on the dipstick.
NOTICE
• DO NOT overfill. Engine overheating and
damage may result.
Figure 26
1. Dipstick (diesel engine)
Figure 27
1. Oil Filler Port (diesel engine)
1
1
JACOBSEN G PLEX II Series: ZV
SAFETY AND OPERATORS MANUAL

HYDRAULIC SYSTEM

Reservoir Capacity
Total System Capacity 25.5L
To check the hydraulic fluid level on units that DO
NOT have the electronic Turf Protection System
(leak detector), locate the sight glass on the tower
portion of the reservoir. Visually inspect to see if
there is 1" (25.4mm) (at ambient temperature) of
fluid visable above the lower portion of the sight
glass. If not, unscrew the reservoir cap and fill to
proper leval (See Fig 28).
Figure 28
1. Sight Glass
2. Reservoir Cap
3. Tower
18.0L
2
3
1
GB-15