Maintenance And Cleaning; Disposal - Conrad Electronic 75 15 32 Bedienungsanleitung

Function selector switch S1 (10) in position 3:
Fixed position.
The camera stays in one position (as set by position selector switch S2 (11)). When motion is detected,
the RELAY contact is active for 10 seconds (while the red status LED (6) flashes).
b) Position selector switch S2 (11)
Position selector switch S2 (11) allows you to set the camera's home position. There are five possible
positions (position 2, 3, 4, 5, and 6).
• The camera moves to the set position when no motion is detected and function selector switch S1
(10) is in position 2.
• When function selector switch S1 (10) is in position 3, the camera moves to the position set with posi-
tion selector switch S2 (11).
To set the desired home position, connect the camera to the power supply and open the front of the
housing. Put function selector switch S1 (10) into position 3. Use a suitable screwdriver to set the
desired home position on position selector switch S2 (11). The camera moves to the set home position
directly.

9. Maintenance and cleaning

No part of this product requires servicing.
Clean the product with a soft, clean, dry and lint-free cloth. Use a vacuum cleaner or a brush to remove
strong accumulations of dirt.
Do not use any cleaning agents with solvents. They can attack the plastic housing.
Do not press on the camera lens strongly when cleaning it, as you may scratch it and thus cause mal-
function.

10. Disposal

Electric and electronic products do not belong in the household waste.
At the end of its service life, dispose of the product according to the relevant statutory reg-
ulations.
26