LaserLiner CableTracer Pro Bedienungsanleitung Seite 20

Sender TX: Set-up
3
Connect the cables to the device. Ensure that the proper polarity is observed when doing so! Use the ON/
OFF button (5) to switch the device on. Depending on the application, the output power of the signal can
be selected using the sender code button (4): level 1 = lowest power; level 3 = highest power. Increasing
the power from lowest to highest expands the operating distance of the receiver RECV by ve times. If
external voltage is present, the LC display indicates the magnitude of the voltage and the warning symbol
(B). It also shows the sender code. To illuminate the display, press the sender code button (4) and hold it
down for 2 seconds. To switch the device off, press the ON/OFF button and hold it down for 2 seconds.
The device can be operated with or without voltage and is voltage-resistant up to 400 V.
4
5
- Be sure to observe the safety instructions when working with live cables.
!
- The integrated external voltage warning (B) of the sender must not replace checking for zero
voltage!
4
Sender TX: Set sender code
If you are using only one sender, it is not necessary to adjust the sender code. If you are using more than
one sender, the sender code must be adjusted. To do this, ensure that the device is turned off. Then hold
down the sender code button (4) and brie y press the ON/OFF button (5). Then press the sender code
button and set the desired code. Set all devices in use to different sender codes. The ON/OFF button then
saves the settings and switches the device on. There are 7 sender codes to choose from.
HOLD
LEVEL
LEVEL
simultaneous
20 GB
B 11
12
CODE
LEVEL
4 5
7
8
CODE
LEVEL
9
10
CODE
LEVEL
LEVEL