Stihl HTE 60 Gebrauchsanleitung Seite 37

STIHL recommends the use of STIHL
original tools, guide bars, chains, chain
sprockets and accessories. They are
specifically designed to match your
model and meet your performance
requirements.
Never attempt to modify your power tool
in any way since this may increase the
risk of personal injury. STIHL excludes
all liability for personal injury and
damage to property caused while using
unauthorized attachments.
Do not use a pressure washer to clean
the unit. The solid jet of water may
damage parts of the unit.
Do not spray the machine with water.
Unsuitable extension cords can be
extremely dangerous.
Make sure that the conductor cross
section (wire gauge) of extension cords
meets the minimum requirements – see
chapter on "Starting".
Clothing and Equipment
Wear proper protective clothing and
equipment.
Clothing must be sturdy
but allow complete free-
dom of movement. Wear
snug-fitting clothing with
cut retardant inserts – an
overall and jacket combi-
nation, do not wear a
work coat.
HTE 60
Avoid clothing that could
get caught on branches
or brush or moving parts
of the machine. Do not
wear a scarf, necktie or
jewelry. Tie up and con-
fine long hair (e.g. with a
hair net, cap, hard hat,
etc.).
Wear steel-toed safety
boots with non-slip soles
and cut-retardant inserts.
Wear a safety hard hat
where there is a danger
of head injuries from fall-
ing objects. Wear safety
glasses.
Wear hearing protection, e.g. earplugs
or ear muffs.
Wear heavy-duty gloves.
STIHL offers a comprehensive range of
personal protective clothing and
equipment.
Transporting the Power Tool
Always turn off the engine.
Always fit the chain guard (scabbard) –
even when you carry the unit for short
distances.
Carry the power tool properly balanced
by the drive tube.
Transporting in a vehicle: Properly
secure the power tool to prevent
turnover and damage.
Before Starting Work
Check that your power tool is properly
assembled and in good condition – refer
to appropriate chapters in the instruction
manual.
– Correctly mounted guide bar
– Correctly tensioned chain
– Never attempt to modify the controls
or the safety devices in any way.
– Keep the handles dry and clean –
free from oil and dirt – for safe
control of the power tool.
Voltage and frequency of the machine
(see rating plate) and the voltage and
frequency of your power supply must be
the same.
English
35