Vacuuming The Tube Fi Lm - Silvercrest SFS 110 A1 Bedienungsanleitung

Vacuuming the tube fi lm
GB
10
You can also suck the air out of the bag (vacuum) during welding:
CAUTION – PROPERTY DAMAGE!
► Do not evacuate bags that contain liquids. These will get into the appliance
and damage it.
1) Lay the open end of the bag as far into the appliance so that the opening of
the bag is located centrally under the lower sealing ring 5. The bag should
be inserted no further than the rear limiters 6 and must lie between the front
limiters 7. Otherwise the vacuuming and welding will not function correctly:
2) Close the appliance lid 1. Ensure that both corners of the appliance lid 1
click closed. If necessary, press them down once again on the markings
so that the appliance lid 1 clicks into place and locks shut.
and
NOTE
Ensure that the upper 9 and the lower sealing rings 5 are not damaged!
►
Otherwise the device cannot suck the air out of the bag.
SFS 110 A1