Qualified Personnel; Scope Of Delivery Of Positioner; Assembly; General - Siemens SIPART PS2 6DR50x0 serie Betriebsanleitung

Qualified personnel

A qualified person in the sense of these Operating Instructions is one who is familiar with the installation,
commissioning and operation of the device and who has the appropriate qualifications, e.g.:
Is trained or authorized to energize, de-energize, ground and tag circuits and equipment in accordance with
-
established safety practices
Is trained in the proper care of protective equipment in accordance with established safety practices
-
Is trained in first aid
-
In the case of devices with explosion protection: is trained or authorized to carry out work on the electric
-
circuits of potentially explosive equipment.
WARNING
!
The device must only be installed and operated by qualified personnel.
The device is designed for connection to functional or safety extra-low voltage.
The electric safety is determined by the power supply units alone.
High positioning forces are generated by pneumatic actuators. To prevent injury, installation and
operation must be carried out under strict observation of the safety regulations.
Reference is specifically made here to the observance of the applicable safety regulations for
potentially explosive equipment.
Correct and safe operation of this device is dependent on proper transport, storage and installation as well as
careful operation and maintenance.
2

Scope of Delivery of Positioner

Positioner as ordered
-
Operating Instructions, German/English (enclosed with device)
-
Leaflet "Operation -- a concise overview", German and English (in the device)
-
3

Assembly

3.1

General

DANGER
!
The positioner and its option modules would be supplied as separate units and in different versions.
Positioners and option modules are available for operation in zones with and without an explosion
hazard. These versions are marked by a special rating plate.
When combining components, make sure that only positioners and option modules can be com-
bined that are approved for the zone where they will be used. This especially applies to safe opera-
tion of the positioner in zone in which the atmosphere might be subject to an explosion hazard
(Zones 1 and 2). In that case it is imperative to use categories (2 and 3) both of the device itself
and its options.
CAUTION
!
It is essential that you observe the following sequence during assembly to avoid injuries or
mechanical damage to the positioner/extension kit:
1. Mechanical fitting of positioner
2. Connection of electric power supply
3. Connection of pneumatic supply
4. Put into operation
SIPART PS2
A5E00074600-05
See Chapter 3 (depending on version)
See Chapter 5, page 54
See Chapter 6, page 54
See Chapter 7, page 57
Operating instructions
45