Manual Address Adjustment; Dmx Control; Indication Of The Firmware Version; Cleaning Of The Unit - IMG STAGE LINE RGBL-82DMX Bedienungsanleitung

RGBL-82DMX units are adjusted to the next free
address in each case:
Start address of the light effect panel No.
Number of
DMX channels
2
6 7
9 10
15 16
24 25
27 28
Fig. 5 Automatic adjustment of the DMX start addresses

7.3.2 Manual address adjustment

1) Press button MENU (11) so many times until the
display (16) shows
next button within 8 seconds, otherwise the adjust-
ing process will end.
2) Press button ENTER (13). The adjusted address is
shown in a flashing way.
3) Use button DOWN or UP (12) to adjust the address
and memorize it with button ENTER.
pears on the display. After 8 seconds the light effect
panel returns to the previous operating mode.

7.4 DMX control

Once the control signals of the DMX controller are
received, the red LED DMX (9) lights up and the dis-
play shows the start address. The light effect panel can
now be operated with the DMX controller.
Important for DMX control via 6, 9, 15, or 27 channels
(not for 24 channels):
For RGB control (direct control of the red, green, and
blue LEDs)
adjust DMX channel 1 to 0 – 28 and
DMX channel 2 to 0 – 15.
The show programmes Nos. 1 – 9 are switched on
via DMX channel 1 from a value of 29 onwards and
their running speed or the music control is then
adjusted via DMX channel 2.
For the colour transition programme
adjust DMX channel 1 to 0 – 28 and
DMX channel 2 for the transition speed to 16 – 255.
3 4 5 6
13 19 25 31
19 28 37 46
31 46 61 76
49 73 97 121
55 82 109 136
. Make sure to press the

8 Indication of the Firmware Version

To indicate the version number of the firmware (oper-
ating system of the unit):
1) Press button MENU (11) so many times until
7
(version) appears on the display (16).
37
2) Press button ENTER (13). The version number will
55
be indicated, e. g.
91
3) After 8 seconds, the light effect panel will return to
145
the previous operating mode.
163

9 Cleaning of the Unit

The eight white plastic covers in front of the LEDs
should be cleaned from the outside at regular intervals,
depending on impurities caused by dust, smoke, or
other particles. Only this will ensure that the light is
radiated at maximum brightness. For cleaning, dis-
connect the mains plug from the socket. Only use a
soft, clean cloth and a mild detergent. Then wipe the
plastic covers dry.
For cleaning the other parts of the housing, only use
reap-
a soft, clean cloth. Never use any fluid; it may leak into
the unit and cause damage.

10 Specifications

Power supply: . . . . . . . . 230 V~ / 50 Hz
Power consumption: . . . 60 VA
Light source: . . . . . . . . . 240 super bright LEDs
Ambient temperature: . . 0 – 40 °C
Dimensions. . . . . . . . . . 1590 × 200 × 110 mm
Weight: . . . . . . . . . . . . . 7.5 kg
= version 2.3.
80 red, green,
and blue each
GB
17