Safety Instructions; General Information; B) Operation - Reely Big Tiger II Bedienungsanleitung



5. Safety Instructions

In the case of any damage caused by failure to comply with these safety instructions the guarantee
will be rendered void. We do not accept any liability for consequential damages!
Nor do we assume liability for damage to property or personal injury caused by improper use or
the failure to observe the safety instructions! In such cases the guarantee will be rendered void.
Normal wear and tear during operation (e.g. worn tires) is excluded from the guarantee, the same is the
case for accidental damage (e.g. broken off transverse link, scratched or destroyed car body etc.).
Dear Customer, the following safety instructions are intended not only for the protection of the product, but
also for your own safety and the safety of others. Therefore read this chapter very carefully before putting
the product into operation!
a) General information
Caution, important note!
Operating the model can lead to damage to property and/or individuals. Therefore, make sure that you are
properly insured when using the model, e.g. by taking out private liability insurance. If you already have
private liability insurance, enquire whether the operation of the model is covered before operating it.
• The unauthorized conversion and/or modification of the product is prohibited for safety and approval reasons (CE).
• The product is not a toy and should be kept out of reach of children under 14 years of age.
• The product may not become damp or wet.
• Do not leave packaging material unattended. It may become a dangerous toy for children.
• Should questions arise that are not answered with the help of this operating manual, contact us (contact information
see chapter 1) or another expert.
The operation and the handling of remote control model cars must be learned! If you have never controlled
such a model, start especially carefully and allow yourself to get used to how it responds to the remote
commands. Do be patient!

b) Operation

• Every time before you use the product, make sure that no other models are being operated on the same frequency
within the range of the transmitter. Control over remote controlled vehicles will be lost! Always use different frequencies.
• Every time you operate the car you must check and, if necessary, adjust the settings of the trim regulator for forward/
reverse driving as well as those for steering.
For this reason the wheels of the car must not be placed on the ground when the car is initially put into operation;
place the model on a suitable base which allows the wheels to turn freely (don't put your hands in the drive!).
After that, adjust the trim settings correspondingly until the motor no longer turns when you let go of the forward/
reverse lever and until the steering assembly is straight (the precise settings for driving straight can be carried out
later on whilst driving).
• When putting the device into operation always turn on the transmitter first. Only then can the rechargeable battery
pack of the car be connected with the drive control and the model be switched on. Otherwise the drive control might
activate unexpectedly which might lead to unexpected reactions by the electric model!
27